Professional Rodent Control in Lexington - Population Math Says You Need Exclusion, Not Just Traps

Rat reproduction follows a similar pattern but at a different scale. Norway rats produce 4 to 6 litters per year with 8 to 12 pups per litter. Roof rats - more common in warmer parts of NC - produce 5 to 8 litters per year. Both species require larger entry gaps than mice (rats need approximately 1/2 inch vs. the 1/4 inch that mice can pass through), but both enter through the same categories of structural vulnerability: plumbing penetrations, damaged vent screens, gaps at the roofline and fascia, and foundation cracks. The entry point categories are the same; the sealing materials and methods scale to the size of the animal and the structural gap.

The most common trap placement mistake is working from a default pattern rather than evidence. Placing snap traps along every wall in a kitchen produces far lower catch rates than placing them on the specific runways identified by smear marks, at the specific corners where dropping density indicates concentration, and near the specific harborage locations identified by nesting material or insulation disturbance. Evidence-based placement converts trapping from a shotgun approach into a targeted clearance process. This is why the assessment precedes any station placement - the evidence determines the strategy, not a standard protocol that ignores what the property shows.

The 14 entry points that most homeowners never find are not exotic or difficult to locate once you know what to look for. They include: gaps around plumbing penetrations in the cabinet undersides (a 1-inch pipe run through a 1.5-inch hole leaves a 1/4-inch annular gap on each side - more than enough for a mouse), HVAC duct penetrations through the basement ceiling or crawl space floor, weep holes in brick veneer (intentional architectural openings that are unintentionally perfect mouse entries), the gap above the garage door track where the top seal meets the framing, the space between the sill plate and the foundation in older construction where sill plate shrinkage creates gaps, roof-fascia separation at the gutter line where repeated thermal cycling opens joints, and dryer vent terminations with worn or missing flap dampers. Most of these gaps are in locations that are never visually surveyed by the homeowner - under the sink, in the crawl space, at the roofline. Our assessment methodology is specifically designed to reach these locations because that is where the entries are.

Attic rodent infestations present a specific set of considerations that differentiate them from standard interior treatment. Contaminated attic insulation - insulation saturated with rodent urine and droppings over a sustained infestation period - is a health and structural concern that requires remediation beyond the rodent control treatment itself. Roof rats are the primary species in attic infestations in warmer parts of NC; Norway rats in the basement or crawl space is the more common pattern in northern areas. The entry point categories for attic infestations focus on the roofline: fascia gaps, broken or missing roof vent screens, soffit-fascia separations, and construction gaps at chimney flashing. Commercial rodent programs add a documentation layer not required in residential treatment: service logs, catch records, station maps, and trend reports are standard requirements for food service establishments operating under health department oversight in Lexington and NC. Show Me Pest Control provides full program documentation for commercial accounts as a standard component of every service agreement.